Procedure

a) Circuit formulation:

1. Connect the circuit to form a Boost converter by dragging the mouse from one terminal to other.
2. After completing all connections click on check connection button and verify the connections.
   a) If all connections are correct then click on circuit diagram button to see the correct circuit
   b) If any connection is wrong then click on red button to remove the wrong connections and redraw the right connections.

b) Operating the circuit:

1. Set the values of Source Voltage (Vg), Load Resistance (R) and Duty Ratio (D).
   
2. Press “RECORD” button to simulate the circuit and observe various waveforms.
   
3. Change “Vg, R and D” to observe the waveforms at different operating conditions.
   

c) Performance analysis of the circuit:

1. Set the values of Source Voltage (Vg), Load Resistance (R) and Duty Ratio (D).
   
2. Select the “ICONS” in sequence to analyse and understand the circuit operation and performance.
   
3. Follow the instructions given in respective experiment slide and press the “RECORD” button to fill the observation table.