Virtual Labs

Design and develop a P & ID for Pressure and Vacuum sensors calibration set-up

What is the definition of calibration?

a: Calibration is the process of configuring an instrument to provide a result for a sample within an acceptable range. Explanation

Explanation

b: Calibration is configuring and verifying a measuring instrument's accuracy to ensure its readings match a known standard Explanation

Explanation

c: Calibration means comparing with standard device and adjusting it for accuracy within the limit Explanation

Explanation

d: All Explanation

Explanation

What is traceability?

a: Traceability is the ability to identify and follow something or someone, or to keep track of information Explanation

Explanation

b: Traceability in calibration is the ability to link the readings of a measuring instrument to a known reference standard. Explanation

Explanation

c: Traceability means knowing and documenting the reference instrument used for calibration of device under test Explanation

Explanation

d: All Explanation

Explanation

What should be the standard operating region of the sensors used in any idustry ?

a: 20% to 80 % Explanation

Explanation

b: 30 % to 70% Explanation

Explanation

c: 0 % to 100 % Explanation

Explanation

d: 10% to 90 % Explanation

Explanation

On what basis the sensors are selected for specific application in an industry ?

a: Range of the sensor Explanation

Explanation

b: Accuracy and Linearity in the operating region Explanation

Explanation

c: Cost of the sensor Explanation

Explanation

d: All Explanation

Explanation

In which stage of the project the design strategy is freezed?

a: At the time of proposal Explanation

Explanation

b: At the time of Errection stage Explanation

Explanation

c: At the time of Commissioing stage Explanation

Explanation

d: At the time of detailed engieering Explanation

Explanation

As a standard practice how much settling time we should configure for storing the readings to PLC for this set-up?

a: Depends on plant lay-out Explanation

Explanation

b: Depends on settling time of sensor Explanation

Explanation

c: Greater than the settling time of sensor but minimum equal to settling time of process Explanation

Explanation

d: The scan time of PLC Explanation

Explanation

What safety feature needs to be included in this set-up so as to avoid any accident?

a: Necessary interlocks Explanation

Explanation

b: Emergency STOP push button Explanation

Explanation

c: Redundancy at PLC level Explanation

Explanation

d: "Fail Safe" operation for all components Explanation

Explanation

Will there be any effect of installation of pressure sensor in the tank as regards to accuracy of the readings?

a: Yes Explanation

Explanation

b: No Explanation

Explanation

Will there be any change in calibration set-up as regards to application for which it will be used?

a: Yes Explanation

Explanation

b: No Explanation

Explanation