Virtual Labs

Tools

Aim

Theory

Pretest

Procedure

Simulation

Posttest

References

Feedback

Aim

Theory

Pretest

Procedure

Simulation

Posttest

References

Feedback

Upsetting Process: An Overview

Choose difficulty:

Beginner

Intermediate

Advanced

Q1. The number of presses shown in upsetting process module are:

a: 4 Explanation

Explanation

b: 1 Explanation

Explanation

c: 3 Explanation

Explanation

d: 7 Explanation

Explanation

Q2. The L/D ratio used in interactive bench of simulation for upsetting process are:

a: 1.0,2.0,3.0 Explanation

Explanation

b: 1.0,1.5,2.0 Explanation

Explanation

c: 5.0,10.0,15.0 Explanation

Explanation

d: 10.0,12.0,15.0 Explanation

Explanation

Q3. Velocity of upper die in simulation for upsetting operation is:

a: 1 mm/sec & 2 mm/sec Explanation

Explanation

b: 2 mm/sec & 5 mm/sec Explanation

Explanation

c: 5 mm/sec & 10 mm/sec Explanation

Explanation

d: 1 mm/sec & 10 mm/sec Explanation

Explanation

Q4. In upsetting operation which die moves:

a: Lower die Explanation

Explanation

b: Upper die Explanation

Explanation

c: Both Explanation

Explanation

d: None Explanation

Explanation

Q5. Which process involves increasing of the cross-sectional area by pressing or hammering in a direction parallel to the original ingot axis:

a: Peening Explanation

Explanation

b: Swaging Explanation

Explanation

c: Upsetting Explanation

Explanation

d: Setting Down Explanation

Explanation

Community Links Sakshat Portal Outreach Portal FAQ: Virtual Labs

AGPL 3.0 & Creative Commons (CC BY-NC-SA 4.0)