Steps to perform experiment

Step 1: Make connections as per the instructions given below:

(a) (1-13), (2-14)
(b) (3-15), (4-16)
(c) (5-15), (6-7), (8-11)
(d) (9-12), (10-16)

Note: Click on the label to delete the connection for the corresponding node.

Step 2: (a) Now, Check the connections by clicking on ‘CHECK’ button.
(b) If the connections are ‘Invalid connections’ click on corresponding node to remove the connection.
(c) And if the connections are ‘Right Connections’ then follow the below steps.

Step 3: Turn on the MCB.
Step 4: Click on Function Generator ‘Power’ button.
Step 5: Now, Vary the frequency by moving the slider.
Step 6: Now, Click on ‘ADD’ button to add the readings in the observation table.
Step 7:Repeat Step 5 to Step 6 until we get the 8th reading in the observation table.
Step 8: In Calculation section, We have to manually calculate the Resonance frequency and Quality factor and verify it with the help of Verify button.
Step 9: Click on ‘PRINT’ button to takeout the print of the webpage.
Step 10: Click on ‘RESET’ button to reload the webpage.