Procedure

Configuration:-

• Select motor size , diameter of drum and check/click the configuration button. (we are considering standard single phase motor sizes)
• Click on Check Configuration

Basic Knowledge -

• Answer all the questions and click on next level

Simulation-

Part A

• Click on motor and start cold water supply
• Click on Engine image and start loading the weight
• Check the spring balance reading and click on Submit button beside meter reading
• Calculate the power and submit the answer to left side text box
• Repeat the process for 5-6 times with different loads and observe the table reading and change in power with weight

Part B

• Start the cold water pump for cooling system
• Start the induction motor with no load condition and check the power sensor reading
• calculate the standard power (upto two decimals) for no load condition and submit the answer
• load the weight , start induction motor and check the sensor power reading (torque sensor reset to zero and engine stops)
• calculate the standard power (upto two decimals) for load condition and submit the answer
• Repeat the same process for from point no. 3, loading the till the maximum weights
• Observe the reading , calculate the standard torque for every observation and submit the answer
• plot the graph by clicking on "show graph" button after taking atleast 5-6 readings

Fault Finding:

1. Observe the shown table and select the fault accordingly
2. After selecting the correct fault. All stages are completed