Develop an application using On-Delay Timer

• In this experiment the on delay timer will be tested for its functionalities using Simulator. Following bits of the
• timer are to be observed.
• Initialising bit "ON" in this case.
• Enable bit "T_en"
• Done bit "T_dn"
• Timer timing bit "T_tt"
• Preset value needs to be entered by the user.
• While configuring the timer thedefault time is 1 mS. Select appropriate preset value as per the need of the application. The screen shot of the configured timer will appear like this.
• To test the EN, DN, and TT bits;configure the timer by right clicking anywhere on the timer block. Submit tag and preset value.

• Add new rung to test the timer status or to energies the output. You can also test the cascading of the timer using these bits.
• Observe the tag name for timer DN bit. See following screen shot to observe the output bit status when delay is over.

• Observe the bit status in Run mode when input a is toggled again.