Procedure

Simulator:

• step 1 : Select Operating Frequency.
• step 2 : Select Timer.
• step 3 : Select Prescaler.
• step 4 : Select Enable Interrupt.
• step 5 : Enter ON Delay (in mS).
• step 5 : Enter OFF Delay (in mS).
• step 5 : Click on "GENERATE CODE" button to generate code.
• step 6 : Click on "COMPILE" button to compile code.
• step 7 : Click on "EXECUTE" button to execute code and goto mimic.
• step 8 : If you want to download code click on "DOWNLOAD" button.
• step 9 : The MIMIC will open on left side of screen.
• step 10 : Click on selected output pin terminal(blue circle) and click on anode terminal(blue circle) for connection of the selected output pin with anode or vice versa.
• step 11 : Click on cathode terminal(blue circle) and click on resistor terminal(blue circle) for connection of cathode with resister or vice versa.
• step 12 : Click on "Check Connection" button.
• step 13 : If connection is wrong, click on "Reset Connection" button and follow step 10, 11 and 12.
• step 14 : If connection is successful, click on Run Button.
• step 15 : Output LED is on. Observe the square wave graph.
• step 16 : Click on "REFRESH" button to re-executing the experiment.