STEP 1 : Make Connections as per the instructions given below:

1.    P₁ of Power supply - P₃ of Circuit Diagram

2.    P₂ of Power supply - P₄ of Circuit Diagram

3.    M₁ of Multimeter - M₃ of Circuit Diagram

4.    M₂ of Multimeter - M₄ of Circuit Diagram

NOTE : If wire is wrongly connected, Click on node number to detach the wire.

STEP 2 : Click on   CHECK  button for checking the connections.

STEP 3 : Turn ON Power supply by clicking on the Power button and set the voltage to 30V.

STEP 4 : Turn ON Switch 1 for charging the capacitor.

STEP 5 : Now, Turn ON Switch 2 for discharging the capacitor.

STEP 6 : Click on   START  button to start the Timer & reading will add to the table automatically until the timer stops.

STEP 7 : Click on   PLOT  button to plot the graph.

STEP 8 : Click on   PRINT  button to print the webpage.

STEP 9 : Click on   RESET  button to refresh the webpage.