Instructions to run the simulator

Simulator contains 6 steps

1. Introduction \
2. Configuration \
3. Connection \
4. Characterization \
5. Calibration \
6. Fault Detection

Procedure to run the simulator's 6 steps:

1. Introduction

• Select the application.
• Read the theory and start the test.
• Attempt all the questions from the test and submit the test.
• Click Next level.

2. Configuration

• Select I/p converter type and do necessary calculation to configure it.
• After Successful configuration click Next Level.

3. Connection

• According to selected I/p converter type, Select the require components from symbol library to do the connections.
• Click check connection button.
• After successful connection click Next Level button.

4. Characterization

• Take multiple readings to check output of I/p converter.
• Plot the graph for the same readings.
• Click Next Level

5. Calibration

• Calculate zero error, span error, linearity and Average Percentage Accuracy.
• Calibrate the I/p converter.
• Remove zero error
• Remove span error.
• Try to get the linearity.
• Click Next Level

6. Fault Detection

• Detect the 3 faults for the I/p converter's few reading.