Procedure

Instructions:

• Before starting the process read the instructions completely
• Click on Start button
• Select the Type of Operation either Welding or Cutting
  • If Welding is selected follow the below steps
    • Select the Type of Joint
    • Select the Type of Material
    • Select the Type of Flame
    • If your selection is correct the simulation of welding starts otherwise it shows error for incorrect selection
    • Observe the welding process
    • Once welding is over press Stop button
    • Repeat the steps with different selction
  • If Cutting is selected follow the below steps
    • Observe the Cutting process
    • Once cutting is over press Stop button
    • Repeat the steps with different selction

Note:

• In simulation window you can zoom in or zoom out by scrolling your mouse
• You can rotate the simulation area by left click and move