Carry out fly leveling using auto level.
Steps to perform experiment
Step-1) Start Button: This button on click will navigate to the menu page consists of three buttons i.e. OBJECTIVE OF EXPERIMENT Button, EQUIPMENT DETAILS Button and OBSERVATIONS & PLOTTING Button.
Step-2) Quit Button: It is used to exit the page.
Step-3) OBJECTIVE OF EXPERIMENT Button: This button provides objective of the experiment.
Step-4) EQUIPMENT DETAILS Button: This button provides equipment details, used in the experiment.
Step-5) OBSERVATION & PLOTTING Button: It contains two buttons ie.e. BROWSER & FLASH BASED SIMULATIONS Button.
Step-6) On click on BROWSER BASED button, it will navigate to the simluation page where you need to click on EQUIPMENT SETUP Button.
Step-7) After this, you need to setup autolevel instrument by placing it on the tripod.
Step-8) After this, click on LEVEL SETUP Button & setup blue bubble dot to the center.After this, click on Next Button.
Step-9) Click on th START Button, staff at point A will appear.
Step-10) Click on the staff at point A & after this, click on the SAVE Button to save readings at point A.After this click on NEXT Button to move the staff at point B.
Step-11) Repeat step 10 for point B,C & D.
Step-12) After click on VIEW READINGS Button to view saved readings.
Step-13) Alidade view of each point is also given at the left side of the pane.
Step-14) Click on FINISH Button to finish the simulation.