Design of Piezoelectric sensor and its application

Enter the force between 1 to 50 (N)
Calculate pressure and enter it's value. If the value is correct, further calculations will be enabled and if the value is incorrect, then formula followed by correct answer will be displayed after 3 attempts
Calculate output voltage and enter it's value, if the value is correct, further calculations will be enabled and if the value is incorrect, then the formula followed by correct answer will be displayed after 3 attempts
Calculate charge Q. After calculating correct answer click on "Next Reading" button and similarly calculate other 4 readings for the same material
After calculating 5 readings, select another material from the top and repeat the same process by selecting another material
After recording 5 readings for the new material, click the "Compare with Previous Material" button

Here, you can compare the difference between the standard calculations for both materials
Click "Next Level" at the top

Here, you can find the difference between standard values and observed values for both the materials
Click "Next Level" at the top

Select the material for testing
Select appropriate dimensions i.e length, width and height and click on check configuration
If the selected parameters are correct, the Height and Weight fields will be enabled, while the remaining configuration parameters above will be disabled
Enter a height between 1 and 100 cm, input the appropriate weight, and click "Start". You will then see the force required on digital meter
Click on "Reset" button and take trials for different height and weight
If the sensor breaks due to certain parameters, click the "Reselect" button to adjust the configuration and repeat the process, taking different trials. After recording 5 readings, you can proceed to the next level's results page