Design of load cell and its characterization

Select the configuration parameters
If column type load cell selected then, calculate area and enter its value if the value is correct, click on Configure. If the entered value is incorrect then formula followed by correct answer will be displayed after 3 attempts
Click on "Next Level"

Click on a component from the left panel to select it. The selected component will appear on the right, where you can drag and drop the component to adjust its position
You can select any component or connection and click the delete button to modify it, if needed
Use drag-and-drop to connect the ports and construct the Wheatstone bridge
After completing the connections, click the "Validate Connection" button to check them. If the connections are incorrect three times, a popup will notify you, and on the fourth attempt, a hint will be displayed. Once the connections are correct, you'll be redirected to the next page

Enter a load between 1000 and 10000 N for the column-type load cell, and for the cantilever-type load cell, the load range is between 10 and 100 N
Calculate Axial Strain and enter it's value if the value is correct further calculations will be enabled and if the value is incorrect then formula followed by correct answer will be displayed after 3 attempts
Calculate transverse strain and enter it's value, if the value is correct further calculations will be enabled and if the value is incorrect then formula followed by correct answer will be displayed after 3 attempts
Repeat the same process for different loads and calculate axial and tranverse strain. Calculate the load for 5 readings and click on next level
Select one of the load to calculate output voltage and click on submit
Select the supply voltage Eb and click "Submit." Note that this selection cannot be changed for next readings
Calculate the output voltage and enter it's value if the value is correct further calculations will be enabled and if the value is incorrect then formula followed by correct answer will be displayed after 3 attempts
Now, calculate the same for the other applied loads
Click on "Next Level" button

Select any load for which you want to calculate the error and sensitivity
Calculate the error for the selected load (error = standard reading - actual reading)
Calculate the sensitivity (sensitivity = actual output / Input)
After submitting the correct value for sensitivity, click on "Result" button for analysis