Calibration of Rectangular Notch
These procedure steps will be followed on the simulator
- Open the Calibration of Rectangular notch experiment and click on the next button shown at the bottom right corner.

- Start the pump by clicking on green button and then click on the next button.

- Click on the inlet valve to rotate it.

- Click on hand to rotate the inlet valve and click on the next button.

- Note the initial reading of the hook gauge and click on the hook gauge.

- Calculate head of water, theoretical discharge of rectangular notch and click the next button.

- Note the initial reading of the hook gauge and click on the hook gauge.

- Calculate head of water, actual discharge of V-notch and click the next button.

- Calculate coefficient of discharge for rectangular notch.

- Repeat the same procedure, after certain trials, click on the red button to stop the pump.
