Answer all the questions and click on "Submit Test" button.
Click on next level button which will appear in place of submit button below the test.
Configuration
Select configuration type, material type, sensor type, and voltage.
Click on "CHECK CONFIGURATION" button.
Mimic
Click on red circle available near terminal label and connect to positive voltage, negative voltage, and ground. Connect all terminals one by one as shown in above circuit diagram of NPN type configuration or PNP type configuration.
Click on "Check Connection Status" button.
Click on "NEXT LEVEL" button.
Animation
Select material type and sensor type for animation of proximity sensor.
Click on "SUBMIT" button.
You can observe the animation by clicking on "Min Sensor Range" and "Max Sensor Range" button available on the screen. If the object goes out of the sensing range, the LED will turn off and object moves toward sensor, the LED will turn on
Repeat Steps 6 and 7 for sensing all material types or targets by Proximity Sensor.
After checking all materials or targets, click on "SELECT ANOTHER CONFIGURATION TYPE".
Change configuration type by clicking on it
Repeat the same steps from steps 1 to 9
After all steps, click on "Result" button.
NOTE : Follow steps of "Configuration", "Mimic" and "Animation" for another type of configuration.
COEP TECHNOLOGICAL UNIVERSITY PUNE
