Click on Components button for components to pop up.
Click on the component, drag them to the test bench and place them as shown in the experiment setup.
After placing the components on the test bench, connect the wires accordingly.
To check your connections click on "Check Connections" button.
If your connections are correct then you may continue to take down the readings, if not then click on "Reset Button" and try it again.
Move the "Gunn Bias" knob and set it to 0.5 or above to record your readings.
Toggle the switch button to get the value of Gunn Diode Current.
Click on Add to table to take down the values of Gunn Bias Voltage and Gunn Diode Current.
Toggle the switch button again for Gunn Bias Voltage and move the "Gunn Bias" knob for different reading.
Repeat the process for almost 7 different readings as you did for the first reading.
Click on "Plot" button to plot a graph as per your readings.
If you want to save the graph click on the camera icon just above the graph.
If you want to take down more readings, then click on "Close" Button.
And repeat the same process to take down the readings as you did for the first reading.
Click on 'Print' button to print your current page (readings and connections) or to save your page (readings and connections) in a PDF form.
