Instructions:

1. Before starting the process read the instructions completely
2. Click on Start button
3. Select the Type of Operation either Welding or Cutting
4. If Welding is selected follow the below steps
• Select the Type of Joint
• Select the Type of Material
• Select the Type of Flame
• If your selection is correct the simulation of welding starts otherwise it shows error for incorrect selection
• Observe the welding process
• Once welding is over press Stop button
• Repeat the steps with different selction
5. If Cutting is selected follow the below steps
• Observe the Cutting process
• Once cutting is over press Stop button
• Repeat the steps with different selction

Note:

• In simulation window you can zoom in or zoom out by scrolling your mouse
• You can rotate the simulation area by left click and move