Instructions for BPSK Simulation (with AWGN + Rayleigh)

Note: Use the input fields to enter the Number of Bits, SNR (in dB), number of multi-paths, excess delay (in ms), bit rate (in bps), symbol duration (in ms / cs), and the carrier frequency (in Hz)
Step 1: Click 'Generate Message' to generate the original message signal
Step 2: Click 'Generate BPSK Signal' to generate the BPSK modulated signal
Step 3: Click 'Generate Rayleigh Channel Multipath (CIR)' to plot the Channel Impulse Response (CIR) for the Rayleigh fading channel
Step 4: Click 'Convolve with CIR' to generate the output after convolution with the channel
Step 5: Click 'ADD AWGN Noise' to add AWGN noise
Step 6: Click 'Plot BER vs SNR' to compare BER with and without Rayleigh fading

BPSK Simulation (with AWGN + Rayleigh)

Number of Bits:
Enter SNR value in dB:
Enter the number of Multi-paths:

Excess Delay: Choose time unit:

Bit Rate (bps):
Symbol duration (ms):
Carrier Frequency (Hz):

Step 1: Click 'Demodulated Signal' for demodulation
Step 2: Click 'Demodulated Signal without Rayleigh' to see the signal unaffected by Rayleigh Fading